Last modified on 9 November 2012, at 17:21

Category:Riveting

English: A rivet is a permanent mechanical fastener. Before being installed a rivet consists of a smooth cylindrical shaft with a head on one end. The end opposite the head is called the buck-tail. On installation the rivet is placed in a punched or pre-drilled hole, and the tail is upset, or bucked (i.e. deformed), so that it expands to about 1.5 times the original shaft diameter, holding the rivet in place. To distinguish between the two ends of the rivet, the original head is called the factory head and the deformed end is called the shop head or buck-tail.

Subcategories

This category has the following 3 subcategories, out of 3 total.

A

R

  • Rivets(5 C, 1 P, 167 F)

T