The transformer secondary is rated for 6.3 Volts @ 8 Amps. It was originally connected in full wave, center tapped, positive ground system, with the upper green wire connecting to the diode disconnected in the picture, the diode cathodes grounded, and the center tap going to the negative output lead. As shown, it has been reconfigured as a half wave rectified unit, positive grounded, with one end of the transformer secondary connecting to the negative output wire, the other end connected to one diode, and the center tap disconnected from the circuit. Also showing in the photo are some 18 ohm carbon composition resistors connected as bleeders.

I, the copyright holder of this work, hereby publish it under the following license:

This file is licensed under the Creative Commons Attribution-Share Alike 3.0 Unported license.

You are free:

• to share – to copy, distribute and transmit the work
• to remix – to adapt the work

Under the following conditions:

• attribution – You must give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use.
• share alike – If you remix, transform, or build upon the material, you must distribute your contributions under the same or compatible license as the original.

https://creativecommons.org/licenses/by-sa/3.0CC BY-SA 3.0 Creative Commons Attribution-Share Alike 3.0 truetrue